pop the hood so you can get to the light and pull the 2 tabs up and release the fixture then pull it twards you twist off and change,repeat the steps backwards and youre done!
go to your nearest Mitsubishi dealer and request a high beam light replacement.
If only the low-beam is out, you will need to replace the low-beam bulb. It is probably not necessary to replace the entire headlight assembly.
The Low Beam AND High Beam are in the same bulb. The procedure to change it will be in the owners manual.
Filament for low beam is burnt out. Need to replace.
According to the 2002 Ford Explorer Owner Guide : The LOW BEAM headlights take bulb ( # 9006 ) Also , the HIGH BEAMS use # 9005
press 1 at a time 6 and am this should reset it if not give me a call i have done quite a few 07828329160
Replace the left size high beam light.
I believe you turn your headlights on low beam and then pull out on the headlight switch
dip beam means that one the front light is not working espicially low light so turn on light then see wich one not working and replace it its too cheep and simple
The light probably burned out. Buy another one and replace it.
The high beam wire on the 2004 Toyota Tacoma is red with yellow stripes. You can use a test light to determine which wire is active when the high beams are on.
a type of light, from a beam of light