Depends on which one, there is an intake manifold and an exhaust manifold.
The intake(normally aspirated)- you have to remove the air intake tube, throttle body, disconnect sensor, injector wires/vacuum hoses. Disconnect the fuel line to fuel rail, then you can unbolt the intake manifold.
The exhaust manifold- is a little hard being against the firewall, you would have to disconnect the O2 sensor wires and exhaust pipe. I would spray the exhaust studs with penetrating lube. The upper nuts you should be able to get from the top, the bottom nuts you will need to get to from under the vehicle with a swivel and extentions.
carbertor
how much to charge to change a stater on saturn
Sell your car.
where is the manifold located on the 2004 dodge stratus 2.7l
when i change the starter corlla ce 2003 I take out a manifold
I am about to do one on a friends car. I know it is located at the rear of the engine(opposite of the timing) under the intake manifold. If you want, email me so I can email you back a step by step(photos included) guide on how I did it. Tyrell.Williamson@rocketmail.com
If it's an automatic you will have to remove the exhaust manifold because the thermostat is located on the backside of the engine on the driver's side under the exhaust manifold.
the knock sensors (there are 2 of them) are located under the intake manifold on the 5.3 engine,,,,,requires complete removal of manifold to replace.
On the front of the manifold
There is no set millage for when you should replace a manifold line and accumulator. Most mechanics only replace when the accumulator and/or manifold lineÊstart to fail.
remove the plastic panel and there are 3 ten mm nuts remove and replace mirror.
what is the cost to replace a 2001 v-8 manifold intake