Unless you are an electronics wiz you change the entire light.
If you are an electronics wiz you can get your local electronics supplier to match up the led bulbs with a sample.
turn signals won't work. changed all the bulbs. Hazard lights work. 1999 Chrysler Sebring hardtop
Check all of you bulbs on the car, more than likely one is burned out...
If the bulbs and fuse are good, replace the turn signal Flasher Relay.
Possibly a bad brake light switch, or bad connection.
Open the trunk and pop/pull the clip near the center of the housing.Removethe housing. To remove the bulbs just push in and turn
I assume you only need to change the bulbs. Go into the trunk and look up. You should see the wires leading to the mounting point for the third brake light, you candisconnect the connectors and then change the bulbs this way.
I know how, just need new bulbs. Do you have some? Mkrue@knology.net
Check bulbs Check stop light switch Also make sure you have the right bulbs model 2057 bulbs.
remove the 2 screws above headlights that you see when you lift the hood...then push whole assembly towards the center of the car to release clips. housing will come out then you can change bulb
no
To replace the bulbs in a 1997 Acura safely prop the hood open. Locate the front headlights and remove the old lights. Replace the bulbs.
When changing the lights on a 1995 Acura Integra remove the dash on the center console and pull it off. Remove all the accessories and reach the old bulbs. Replace the bulbs.