You have to remove the Intake
To replace a lower radiator hose on a Ford Focus, use a bucket to catch any antifreeze that might leak. Loosen the clamp from both ends on the hose that needs to be replaced. Put the clamps on the new hose and reposition the hose on the radiator and the other end where it needs to go. Tighten the clamps. Refill the radiator with antifreeze.
To remove a stubborn clamp on a collapsed PCV hose on a 2000 Ford Focus ZTS, cut the hose lengthwise, being careful to get part of the cut under the clamp. Then replace with a new hose and clamp.
This one's a no-brainer. Go to Auto Zone, et al, and purchase the hose, look at the other one, remove and replace.
how to replace ac hose assembly on 2005 jeep liberty
To replace the antenna on a Ford Focus remove the antenna from the base using a screwdriver. Remove the lighting assembly hose with a small key. Remove the plug in wires and the plastic housing. Put the new antenna base in place than screw in the new antenna.
Which one?
On the suction side only if you are just using a do it yourself kit........ The low side service port is on the suction side (larger hose) and the high side service port is on the discharge hose (smaller hose)......
On the drivers side on the engine block. follow the hose that comes from the back of the valve cover. may have to remove intake manifold.
Check out this link. http://autoparts.cardomain.com/auto-part/129552-ford-focus-dayco-dy72079-bypass-hose We have the same problem yesterday with our 2001.
The easiest way to fix a 1988 Ford Bronco gas hose leak is to replace the hose. You can also patch the week in the hose.
you replace it
Lok at the engine end of the upper radiator hose no its not its at the lower end of the radiator hose end