EA fords dont have push rods. Camshaft is on top of the head and the hydraulic lifters are are also located in the top of the head.
Ford EA Falcon was created in 1988.
Is it possible to change Ford EA fuel injection carburettor to normal carburettor?
depends on ea falcon, is it 3 or 4 speed? and age of ea, if its 4 speed and a later ea u can, the other problem is the gear shift handle, the differ slighty from ea, eb, ed, to ef ef series, but a little stuffing around u can get it
Can you use the alternator from an EA ford falcon sedan 89 model to put in a EB ford falcon sedan 91 model?
dont bother its a ford
cd player security codes
i have a 1996 ford ranger 2.3 4 cylinder automatic ,just had the trans rebuild and driveshaft but theres still a bit of play comming from the differential ea. time i either put it in gear i feel a boom from the rear (not the driveshaft nor trans) is it a big job to replace the rear diff? and $$$ ???? Ron
the pipe that comes out of the top of the radiator that goes into the engine
1.1mm +/- 0.1
tfi module on distributer fail.
With the hood open, remove the plastic cover the exposes the inside of the headlight. There are 3 clips to remove from the inside, plus the wire harness. The headlight just comes out from the out side then. You might have to replace some of the clips, only found at Ford, and about 7 bucks ea.
Just pads? approx. $30-50 If it needs rotors? Probably $50 ea. If it needs calipers? Probably $50 ea.