0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is it recommended to replace rear axle seals but not the bearings on a 1996 Chevy S-10 4wd?
It would be recommended to replace the rear axle bearings and axles when they are worn/bad. If the bearings and axles are okay, just replace the seals.
WHAT IS THE REAR AXLES?
On a rear wheel drive vehicle, the rear axles transfer power from the rear differential to the rear wheels.
What is the rear axle in a 2001 Chevrolet Suburban?
The rear wheels are bolted to the axles. The axles run through the inside of the rear end housing.
How do you replace the rear end on a 1999 Mustang?
Remove wheels Remove brake lines Remove driveshaft Support rear end at axles Loosen and remove springs "U" Bolts
Where can i find Kubota rtv front axle replacements and cv joints?
You have to buy the whole axle....cost about $486 on line from Coleman Equipment they do not sell individual parts. Kubota knows that these axles are only good for about 400 hours. this is some of the first junk that Kubota has made. Most of their stuff is good for at lease 2000 hours. Sad but true, the rear u joints can be bought on Ebay at about half price.
What is the secret to removing the rear axles to replace the bearings on a 2000 GMC Safari 2WD?
you need to remove the rear axle cover then remove gear holding bolt usually a 8mm bolt head then remove pin about a inch in diameter, turn rear gears until you can sccess c-clips from axle with magnet then remove rear whells and brake drums then pull the axles out.
Are rear axles interchangeable?
depends if you are talking about the whole rear end or just the axles themselvs, and yes to both of them but if you take out 3/4 ton axles you will need 3/4 ton axles to put back in and so no. if you take the whole rear end of a 1/2 ton and put in a 3/4 ton rear end it should fit well
How do you replace a rear wheel bearing on a 2001 Mitsubishi spyder?
Remove axles and wheel with leverage bar. Remove caliber assembly. After removing the entire front mechanisms. Replace them with new, and reassemble tires.
How do you changerear axle seal 86 c10?
You will need to remove the rear axles so, lift and support the rear of the truck. Remove both rear wheels and brake drums. Remove rear diff cover, you will need a drain pan to catch the gear oil. Remove spider lock bolt and spider pin. Remove both axle "C" retaining clips. Remove both axles. Now you can R & R the rear axle seals. Inspect the rear bearing wear surface on both axles. If you can feel a ridge where the bearing rides on the axle and/or that area is pitted, replace the axles and bearings as needed. Reassemble in reverse order. Fill diff with new gear oil.
What garden tractors had rear PTO?
Kubota GT 850 has rear pto and 3 point linkage
How many axles does a rear wheel drive car have?
2
What holds axle?
How does the clip for rear end axles come out?
