0
Most (not all) Fiero engines require the engine be removed from the car and the seal removed after that.
The engines use a one piece seal in most engines.
It is also possible to remove the transmission to do this, but either way you need to separate the engine and trans, pry out the old seal, and install new.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Does 1986 Pontiac Fiero hood raise from the front or the back?
The front hood raises from the rear or windshield end, the rear hood raises from the rear or bumper end
How do you push the pistons in to the caliper of a Pontiac fiero?
that depends if it is front or rear calipers
Is the 1986 fiero real wheel drive?
Yes , it's rear wheel drive
How do you remove engine craddle from 1986 Pontiac Fiero GT?
There are two horizontal bolts at the front of the cradle, and two verticle bolts at the rear. You do of course have to deal with the engine, transmission, brakes and suspension also.
How do you loosen the alternator on a 1986 Pontiac fiero?
There are two bolts to loosen to adjust the alternator belt tension. 1st is the adjustment bolt. 2nd is the pivot bolt It is easiest to get at them from the bottom of the engine on the passenger side rear of the engine.
Does a 1986 Pontiac Trans Am have a Posi Rear End?
Yes
Where is the alternator on a Pontiac fiero gt?
The alternator lives low on the passenger side rear of the engine. Repair and adjustment done from underneath
How do you replace the rear door lock on 92 Transport?
how do you replace rear door lock assembly on 92 pONTIAC tRANSPORT
Where is the gas tank located on a 1988 Pontiac fiero?
The 12.5gallon gas tank in mounted between the driver and passenger seats along the tunnel from the front to rear firewalls.
What parts are needed to replace the rear drum brakes on a 1997 Pontiac sunfire?
The only part that is needed to replace your 1997 Pontiac rear brakes is a break assembly kit. The brake assembly kit will have everything you need.
How do you replace rear shocks on a Pontiac G6?
The rear shocks on a Pontiac G6 are replaced by supporting the rear axle on jack stands, removing the wheels, and unbolting the shocks. New shocks can then be put in place and bolted on.
How do you replace the rear speakers in 2006 Pontiac G6?
go into the trunk and disconnect the wires and then pull the speakers out from the trunk and replace.
