0
How do you replace rear passenger door window frame on land rover discovery td5?
Wiki User
∙ 12y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace a passenger front window for ford escort 98?
Insert the window into frame
How do you replace a window motor and regulator on a Ford E150?
how do I replace the passenger side window regulator on an E250, 2006. the window will not release to push to top of window frame only half way?
How do I replace a single hung window?
Remove the old window along with the frame then install a new pre-hung window with the frame included. The new window can be any type you want as long as it will fit into the same opening.
How do you replace 3rd door window frame on 1997 GMC Sierra?
Good question.
How do you repair the rear window frame the bottom is rusted out?
The best would be to replace the whole frame with an aluminium frame, may be expensive but the frame will most probably outlive the building!!!!
How do you stop a bad draft on the front passenger side of a expedition?
Where exactly is the draft coming from? If is from the door frame around the window area? If so then your door frame is bent a little. Bent is back to place. The gap between the window frame and frame shouldn't be more than a sheet of paper.
Where is the window motor relay for the passenger side on 89' mark vll?
Inside the metal frame of the door on the passenger side clipped to the frame. hey if your window motor works but your window doesn't go up or down, its "Ford window regulator studs", autozone has them for like $5-$10, there is 3 to a pack and easy to install...Hey go to www.lincolnsonline.com and find the TECH link, they have so much there to help on many problems...
What is the first thing that needs to be done when replacing a window?
When replacing a window, be sure to take measurements carefully. Make sure the new window obtained will fit in the existing frame. It is best if there is a professional to replace the window.
How do you replace a rear door lock actuator in a 2003 land rover discovery ii?
With the front you need to remove the window frame to access the actuator. 5 bolts for the front window. 4 on all 4 corners of the frame and one directly in the middle. You might have to rip some of the plastic, use a box knife so you can tape it back up. After you remove the frame the actuator will be 100% easier to replace, you can actually see what you're doing. Also, the bolts are different sizes, do NOT THINK they can be interchanged. Long bolts go back where they came from, same with the short bolts. Good luck!ADD: Forgot to mention. Pull the frame slowly off the window, then lower the window a bit with your hand supporting it. There will be two screws holding the window to the regulator, unscrew them and lift the window out. Find a nice patch of grass to lay the window. When you put it back together remember, window in fist, bolt it in! Then, slide the frame over the window and tighten it down.Remember, roll your window all the way down with the door open. The black frame around the window. Yes you must remove the torx bolts to get the frame AND the actuator out, you can run to Lowe's and pick up the torx bits for cheap. Once the interior panel is removed there is no other metal frame just plastic wrap. It's hard to imagine but once you get frame and window out it will create A LOT more room to access the actuator. Oh, be VERY careful not to bend your window regulator rolling it up and down when the window is out, learn from my mistakes! One more thing, don't unplug your battery, you'll need to roll you window up and down to access the window regulator bolts.
How would I go about soundproofing a window?
Replace the window with a vinyl framed "double/triple paned" glass window, available from your local hardware store. Add another window on the inside frame of your existing window. Place a sound barrier in the window frame, blocking the sound (and the light). Use acoustical drapes tove "snap-in" w block sound as they do in Hotels/Motels.
What could be wrong when the passenger side window switches do not operate the windows but the driver side switches do operate the passemger windows.?
Does this car have a safety lockout of the passenger switches? It's probably activated. If it was just one passenger window I would suspect a broken wire, most likely in the rubber bellows between the door and frame.
How do you get to the wiper motor on a 1994 YJ 4-cylinder?
undo the bolts that atatch the roll bars to the window on drivers and passenger side, the undo the bolts on lower window that hold the window to the tub on both passenger and drivers side. the window should now fold outwords onto the hood, once it is on the hood the wiper motor will on the drivers side window frame. remember to disconect the battery before any of the steps
