To replace the rear tail light lens on a 2004 Kia Amanti, first, open the trunk and locate the access panel behind the tail light assembly. Remove the screws or clips securing the tail light assembly, gently pull it out, and disconnect the wiring harness. Replace the old lens with the new one, reconnect the wiring, and secure the assembly back in place with screws or clips. Finally, test the lights to ensure they are working properly.
The taillights are an assembly. The lens covers can not be replaced separately
GET A FLATHEAD SREWDRIVER AND LEVERAGE THE LENS SLOWLY UNTIL ITS OULL OFF. BE CAREFUL NOT TO CRACK THE LENS. ONCE PULLED OUT, ALL LIGHT CAN BE REPLACED.
Carefully pry the lens off - pull out the bulb - press replacement bulb into socket - reassemble lens.
Question isn't clear. Are you asking how do you replace the bulb -OR- how to remove the entire lens assembly?
Unscrew the lens, replace the bulb, and put the lens back on.
You can not, you will have to replace the entire tail light.
r=open lift gate, remove 2 screws, gently pull out lens assembly, replace top bulb with #1157
To replace the tail light lens on a Ford 500, first, open the trunk and locate the access panel behind the tail light assembly. Remove the screws or clips holding the tail light in place, then gently pull the assembly out. Disconnect the wiring harness, remove the lens by unscrewing it, and replace it with the new lens. Reassemble everything by reconnecting the wiring, securing the tail light, and closing the access panel.
I Figured it out. The dome light lens is hinged on the passenger side so you just pry the driver's side of the lens out and down to replace the bulb. The lens does not come completely like on other models.
To replace the dome light gently squeeze the lens to release the clips and remove. Next release the bulb from its mount. Install the new bulb and replace the lens.
Remove the dome light lens, pull the old bulb out, and replace with new bulb; replace the lens.
To replace a light bulb in the map light on a 1996 Toyota Camry, the lens for the light has to be removed. There are clips at two opposite ends that have to be nudged gently with a flat screwdriver to get the lens cover off.