GET A FLATHEAD SREWDRIVER AND LEVERAGE THE LENS SLOWLY UNTIL ITS OULL OFF. BE CAREFUL NOT TO CRACK THE LENS. ONCE PULLED OUT, ALL LIGHT CAN BE REPLACED.
Carefully pry the lens off - pull out the bulb - press replacement bulb into socket - reassemble lens.
The taillights are an assembly. The lens covers can not be replaced separately
The lens comes off. There's two indentations opposite the switch, on the front edge of the lens. Use a small flat bladed screw driver to remove the lens.
1991 Honda what?...... Honda makes a lot of stuff.......
Open the hatch - exposing the mounting screws going through the plastic lens housing into the body sheet metal. Remove the screws - lift/slide out the lens housing exposing the light socket. Turn socket slightly in housing and remove. Change bulb - Re-assembly is the reverse of removal.
Question isn't clear. Are you asking how do you replace the bulb -OR- how to remove the entire lens assembly?
For Honda Accord 95: Use small blade screwdriver to gently pry front edge of dome light lens cover off of its retainer. Use fingers or screwdriver to remove lamp bulb. Replace lamp bulb with the same type bulb. Be certain that the size of the new lamp barrel is the same as the old lamp. Reseat the dome light lens cover into its retainer. Note the orientation of 4 tangs on the lens cover that must seat into the lens retainer. Check to verify proper operation of the dome light and its switch.
Unscrew the lens, replace the bulb, and put the lens back on.
You can not, you will have to replace the entire tail light.
Open the rear glass hatch. Remove the screws holding the plastic lens to the body pillar. Pull the lens away from the pillar and remove the bulb socket from the lens housing. Replace the bulb and re-install.
To change the map light bulb on a Honda Ridgeline, first, locate the map light fixture on the ceiling. Gently pry the lens cover off using a flat tool or your fingers, being careful not to damage it. Remove the old bulb by pulling it straight out and replace it with a new bulb, ensuring it is securely in place. Finally, snap the lens cover back on.
r=open lift gate, remove 2 screws, gently pull out lens assembly, replace top bulb with #1157