The lens comes off. There's two indentations opposite the switch, on the front edge of the lens. Use a small flat bladed screw driver to remove the lens.
Open the rear glass hatch. Remove the screws holding the plastic lens to the body pillar. Pull the lens away from the pillar and remove the bulb socket from the lens housing. Replace the bulb and re-install.
You should be able to access it when you remove the taillight lens from the rear pillar. Open the rear hatch - remove the screws holding the lens housing in place and carefully remove the lens housing from the pillar. The wires leading into the back of the lens housing are attached to the socket. Turn the socket slightly to unlock it and remove the socket and bulb.
For Honda Accord 95: Use small blade screwdriver to gently pry front edge of dome light lens cover off of its retainer. Use fingers or screwdriver to remove lamp bulb. Replace lamp bulb with the same type bulb. Be certain that the size of the new lamp barrel is the same as the old lamp. Reseat the dome light lens cover into its retainer. Note the orientation of 4 tangs on the lens cover that must seat into the lens retainer. Check to verify proper operation of the dome light and its switch.
GET A FLATHEAD SREWDRIVER AND LEVERAGE THE LENS SLOWLY UNTIL ITS OULL OFF. BE CAREFUL NOT TO CRACK THE LENS. ONCE PULLED OUT, ALL LIGHT CAN BE REPLACED.
To change a Honda 300 Fourtrax headlight, first unscrew the lens and remove it, twist the bulb out of the socket, insert a new bulb and then replace the lens.
Open the hatch - exposing the mounting screws going through the plastic lens housing into the body sheet metal. Remove the screws - lift/slide out the lens housing exposing the light socket. Turn socket slightly in housing and remove. Change bulb - Re-assembly is the reverse of removal.
Remove the two screws that hold the lens on, remove the lens and change the bulbs.
You will need pliers to remove the wire strip that keeps the light in the socket, then remove the lens. Carefully remove the bulb making sure there is not power in the light then replaces the bulb and reattach the lens and wire.
It's in the owner's manual. You lift the rear hatch and remove the screw holding the lens. Then gently pull the plastic lens toward the rear of the car. The bulb can then be removed and a new one inserted.
Remove the two screws from the lens. Rotate the bulb holder 1/8 turn counter-clockwise and detach it from the lens housing. Pull the bulb straight out. Re-install in the reverse order.
Remove the two screws in the lens. You can remove the entire assembly once you do this.