answersLogoWhite

0

You have to take off the wiper arm and then take the nut off of the post that the arm attaches to.

On the inside of the van take the trim panel off of the tailgate,then you can get at the bolts that hold the wiper motor onto the tailgate.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

HOW DO YOU REPLACE A FRONT WINDSHIELD WIPER MOTOR ON A FORD 2003 EXPLORER?

You will have to remove the wiper arms, then remove the cowl, and then the wiper motor.


How do you reposition a wiper for a 2003 venture?

Replace wiper motor with a new one. Do not install a rebuilt motor on this vehicle.


How do you reset the reset position for wiper arms on Chevy 2003 venture Van?

Replace the wiper motor with a NEW one (do not use a rebuilt!)


My 2003 Chevrolet PU windshield wiper intermittant is jerky. Should I replace the motor or the switch?

The swith


How do you replace the rear wiper motor on a 2003 Pontiac Montana?

Are you sure it's the wiper motor ? I had problems with the rear wiper motor not working on two of my previous vehicles. Cheerokee and Tribute. They both had seized shaft. The shaft going from the motor to the wiper arm goes right through a bushing and that's where the problem occures. Over time the shaft rust and seize up. All you have to do is to clean the shaft and lubricate it. I hope you have the same problem I had, its a lot cheaper to clean it all up then to buy a new motor.


How do you replace wiper blades on a 2003 Dodge Caravan?

How to replace Wiper Blades on 2003 Dodge grand caravan ?


How do you change 2003 Honda Odyssey rear wiper motor?

Remove the rear wiper arm from the wiper motor. Remove the wiring harness from the wiper motor. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.


How to change Pontiac aztek 2003 windshield wiper motor?

To change the windshield wiper motor on a 2003 Pontiac Aztek, first disconnect the negative battery cable to ensure safety. Remove the wiper arms by loosening the nuts at their bases and lifting them off the motor shaft. Next, access the wiper motor by removing the necessary interior panels and disconnecting the electrical connector. Finally, unbolt the motor from its mount, replace it with the new motor, and reassemble in the reverse order.


How do you replace rear window cleaner nozzle on 2003 Pontiac Montana?

To replace the rear window cleaner nozzle on a 2003 Pontiac Montana, first, locate the nozzle on the rear wiper arm. Gently pull it off the wiper arm using a flathead screwdriver if necessary. Then, attach the new nozzle by pushing it onto the wiper arm until it clicks into place. Finally, test the new nozzle to ensure it sprays correctly.


Where is the wiper motor pulse board located on a 2003 Chevy silverado?

Behind the plastic cover on the wiper motor.


How do you replace the rear windshield wiper motor on a 2003 ford escape?

Rear Wiper Motor R&R Remove the rear pivot arm. Lift the pivot arm to the upright position. Slide the locking tab out. Pull up and remove the pivot arm. Remove the rear wiper motor shaft nut cover. Remove the rear wiper motor shaft nut. Remove the rear wiper motor cover. Remove the rear wiper motor bracket nut. Remove the bolt and the rear wiper motor. Reverse these steps to install.


How do you replace the Rear Wiper Motor on a 2003 Ford Escape?

Rear Wiper Motor R&R Remove the rear pivot arm. Lift the pivot arm to the upright position. Slide the locking tab out. Pull up and remove the pivot arm. Remove the rear wiper motor shaft nut cover. Remove the rear wiper motor shaft nut. Remove the rear wiper motor cover. Remove the rear wiper motor bracket nut. Remove the bolt and the rear wiper motor. Reverse these steps to install.