Crankshaft Sensors

How do you replace replace the camshaft position sensor?

001

Top Answer
User Avatar
Wiki User
Answered
2013-06-10 22:06:20
2013-06-10 22:06:20

In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l


where is the camshaft position sensor located on a 1999 Oldsmobile intrigue


how to remplace position of oxigen sensor


How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin


I changed only the camshaft position sensor on my 2000 Kia Sportage. So I don't think so.


do you need to take off the timing belt to replace a camshaft position sensor on a 2006 kia sorento


The camshaft position sensor is located near the thermostat housing. You should replace the crankshaft position sensor as well. This one is much harder to locate....it is on the backside of the engine that is between the firewall and the engine block. Both use the same sensor.


the camshaft position sensor is on the left side of the engine , at back on the upper side . you have to demont the conector , than unscrew and replace it


If I'm not mistaken, I think the camshaft position sensor on these engines is built into the distributor. You'd have to replace the whole thing.


It is located on the backside of the engine. Go to youtube and type in how to replace camshaft sensor on 2005 Nissan altima and it will show where it is and how to replace it, that is how I did my one.


Where is the camshaft position sensor on a 2005 Expedition?



The 1995 for Crown Victoria camshaft position sensor can be found on the back of the cylinder head. The camshaft position sensor will be labeled as such.


location of the camshaft sensor


in the distributor, you have to replace the whole unit.


Camshaft position sensor circuit malfunction.Camshaft position sensor circuit malfunction.


Yea, the crankshaft sensor is under the distributor and the camshaft sensor is inside the distributor, you cannot change it so you will have to replace the whole distributor.



The Pontiac 2.2 liter engine camshaft position sensor can be found on the back of each cylinder head. The camshaft position sensor should be labeled as such.


There isn't a camshaft position sensor. If you are asking because of an error code you received, it is caused by a signal that mimics the same signal as a camshaft position sensor.


The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.


The Camshaft sensor is located in the distributor.



Show me how to replace the camshaft position sensor on a 2000 volkswagen new beetle




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.