I changed only the camshaft position sensor on my 2000 Kia Sportage. So I don't think so.
Replace the crankshaft and camshaft senors and then clear the codes with an oBD II engine scanner and that will fix it.
The crankshaft position sensor must be behind the timing belt cover next to the crankshaft and behind the crankshaft pulley. The camshaft position sensor is again under the timing belt cover next to the camshaft and behind and the camshaft pulley. Is it the same place in 2000 Camry 4Cyl? Do you have pictures of the location? Hard or easy to replace, and what tools do I need? Thanks alot
The crankshaft position is on top of the transmission bell housing on the drivers side. The sensor can be replaced by unbolting and unhooking the plug.
Yea, the crankshaft sensor is under the distributor and the camshaft sensor is inside the distributor, you cannot change it so you will have to replace the whole distributor.
The camshaft position sensor is located near the thermostat housing. You should replace the crankshaft position sensor as well. This one is much harder to locate....it is on the backside of the engine that is between the firewall and the engine block. Both use the same sensor.
In order to replace the camshaft position sensor, you would need to disconnect the electrical plug holding it in. Using a socket, hold down the bolt and remove the camshaft position sensor.
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
The interrupter magnet is normally replaced by removing the camshaft gear as the magnet is inserted through the back side of the gear.
Check out the related link for a video on how to replace a crankshaft position on a Ford Focus SE.
try to replace the camshaft position sensor located under the power steering resivoir .. on 4.6 liter lincoln ...
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
How do u replace the camshaft sensor for a 2000 Nissan xterra 3.3L and where is its locatoin