answersLogoWhite

0


Best Answer

Fault code: P 0446. The valve is located behind the fender and beside the gas fill pipe. Jack up the rear of the car. Remove the hose and wire harness. Below the valve is a metal bracket support bolt. Remove it. The bracket should then slide out towards the rear of the vehicle.

After the bracket is removed put a flat screwdriver into the middle of the bracket support to release solenoid, (note where the valve is located on the bracket for the new solenoid position).

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the Evaporative Emission Canister Purge Solenoid Valve on a 2001 Buick century custom?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

2000 buick century codeP0440 - evaporative emission control system malfunction where is canister and purge soleniod located how can you check themi replaced gas cap?

underneath, in the back; before the gas tank.


Where is the evap purge solenoid located on a 1996 Buick century?

Raise the hood. On the right side should be a sticker that show you. Next to the canister with a plug on top of it.


Where is the Emission Vent control solenoid located on 2003 Buick Century?

It is located immediately underneath and behind the drivers side rear wheel, high near the gas tank filler hose. A 3/8" wrench will remove one bolt, allowing braket and solenoid to drop down.


Shift solenoid 98 buick century location?

The 1998 Buick Century shift solenoid is located on the top of the transmission. The shift solenoid can be access through the shifting console.


Where is the charcoal canister on a Buick Century?

Charcoal canister is underneath your engine next to the gas tank. Cant miss it.


Where is the shift solenoid located on a 1998 Buick Century?

on the valve body


Where is the solenoid on a 2001 Buick century?

There are several solenoids on that vehicle. We need to know which one.


What is PO452 code for 99 Buick Century?

Evap Emission Control System Pressure Sensor Low


How do you clean evap canister on buick century 2001?

Evap Canisters on all gm vehicles are not servicable from 1990-2009 year


What does P1860 diagnostic code on your 1997 Buick Century mean?

Trouble code P1860 means: TCC PWM Solenoid Circuit


Where is the starter located on a 1993 buick century v6 3300?

The starter and solenoid are mounted together on the bottom front side of the engine


Why does a check engine light on a 1998 Oldsmobile Century come on?

usually indicates a problem in the emission control system - have vehicle scanned to determine the problem