where is the thermostat on a 1999 mazda protege?
If a 1999 Mazda Protege keeps making clicking noises, you might have a bad alternator or starter. You could also have a bad ignition or solenoid.
The filter is on the backside of the engine, next to the alternator. It can be reached from underneath.
Where is the flasher relay on the 1999 mazda protege
Yes, 1999 Mazda protege window issues indeed....
the altenater is located on the bottom, closest to the fire wall
The cost to replace a 1999 Mazda Protege serpentine belt will vary depending on the cost of parts and cost of labor. The prices for the serpentine belt start at $14.56.
You can use the end of the tire iron to remove the lug bolts off a 1999 Mazda Protege DX.
The only fuel filter on the 1999 Protege is a "sock" on the fuel pump pickup tube inside the gas tank. The sock can't be replaced seperately from Mazda, you have to replace the fuel pump which does not include the sending unit.
in the stearing wheel
Yes it does have ABS. The older Protege 1997 and older dosnt.
whar are the torque specs for head bolt on a 1999 Mazda protege 1.6 engine
How do I replace the alternator on my 1999 Kia Sportage
under the trottle body
The 1999 Mazda 626 alternator is located on the right hand side of the engine. The alternator will be near the front of the engine.
The 1999 Mazda Protege DLC fuse can be found in the fuse box. The DLC fuse will be at the bottom of the first column.
The Main Voltage regulator it built into the Alternator There is also one on the instrument panel to stabilise the voltage to the gauges
i think it does nt have one
No , the 1.8 liter 4 cylinder in a 1999 Mazda Protege is not an interference engine
follow the bottom radiator hose up to the engine and remove the two bolts an you should see it
Yes, they are only good for either 60,000 or 100,000 mile depending on which type was used.
Inside the fuel tank
It can run between $160 and $250+ to replace the clutch on this car. It depends on the part price, and the charges for the person replacing the clutch.
you needs a dpfe sensor