You can use the end of the tire iron to remove the lug bolts off a 1999 Mazda Protege DX.
12.5mm
Lug: 5X114.3 assuming lug pattern
1/2 Studs
I believe it is 4x100. Most civic and corolla wheels should fit.
the lug pattern is 4x100 so cars like Mazda protege and Honda civic
How do you pull the wheel bearing assembly out from hub far enough to squeeze new lug nuts into place? The car is a 1999 Monte Carlo Z34.
Lug studs on a 1994 Acura Integra is pressed into the hub. To remove the lug studs safely raise and prop the car. Remove the wheel, brake components, and suspension parts from the hub. Press out the old studs.
The brake caliper will have to be removed as well as the brake rotor. Then the studs can be hammered out. The new studs need to be pushed in as far as possible, then using washers as spacers the lug nut can be tightened up to pull the lug into place.
Wheel studs/lug nuts.
You have to have the hub pressed out of the knuckle to replace the wheel studs.
My 2002 Tribute has 19mm lug nuts.
It depends on how many lugs there are. If they areboth 5 lug than it will fit. If the 87 is 4 lug then you would have to change the hubs to 5 lug.