Alternators
Mazda 626
Mazda Protege
Pulleys

How do you replace the alternator belt on a Mazda Protege 1995?

212223

Top Answer
User Avatar
Wiki User
Answered
2006-02-26 04:04:03
2006-02-26 04:04:03

you have to loosen the top alternator bolt alowing the alternator to swing forward loosening the belt

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


you have to loosen the top alternator bolt alowing the alternator to swing forward loosening the beltThis answer was retreived from the previous page


next to the alternator, near the bottom of the firewall side.


Yes it does I too own a Mazda protege 95 with a 1.5 liter and i had to replace the tone ring on my mazda. I ask what does this do and the shop told me its for the abs. But only the LX and ES model has it.


What's the firing order for a 96 Mazda protege


le filtre a huile a transmission est dans pane a l'huile a transmission!


my cluch is lost pressure and the geare doest notwork even i have change the valve onbelow


powersteering belt off first, then water pump, each has its own ten.


Which one of the sensors cause the car to putt putt once the car has gotten hot on a 1995 Mazda Protege?



It takes about .9 of an hour to change regardless of which engine you have.(book time) it is located on the distributor, you have to remove the distributor to check it and/or replace it.


To replace the alternator on a 1995 Honda Civic disconnect the battery. Disconnect the wiring from the alternator. Loosen the adjustment bracket so the belt has slack. Remove the alternator belt along with the mounting hardware. Pull the alternator and replace it.


Could be a bad rebuild unit or a bad battery. It could also be the type of driving and accessories that the unit supports.


how do you replace an alternator on a 1990 integra


You may want to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.



Well I had a 1995 Protege but I think is on the same place. It's beehint the right corner of the front cover. You have to remove the black cover under the car to see it. Mazda hide pretty well.


The relay is H270 above the fuse block next to the clutch pedal.


Remove the wiring harness from your 1995 Mercury Villager alternator. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install your new alternator.


The 1995 Infinity alternator can be replaced by removing the alternator belt. Removing the wiring harness from the back of the alternator. Removing the alternator retaining bolts. Put the new alternator on and reverse the process.


Check the pulley alignment on the alternator (as you view it from the side) and also the other other pulleys that use the same belt. The pulleys should all line up otherwise the problem you're having will occur. Even a small misalignment can create problems. Also, replace the belt tensioner and check bearing condition in the other pulleys.


Have vehicle scanned at auto parts store--most will do this free



try taking the bolt out for the motor mount on that side where alternator is and jacking the motor up.


on the alternator on top is a bolt losen that bolt and it will allow you to move alternator causing belt to losin


There could be many reasons why a 1995 Mazda MX6 is not starting. Some of the reasons could be a bad alternator, starter, battery, or fuel pump.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.