0
not fun at all, there are three bolts holding it on, maybe just two, but it has to go out the bottom of the car, hope i helped
Not hard at all. Just did it about two hours ago. the job takes about 30 minutes all together. One bolt on top and one exactly opposite it on the bottom.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
Where is the EGR valve on a 1992 Mazda Protege?
Were is the egr on a 1992 mazda protege
Where is the headlight relay in 1992 Mazda Protege?
Where is the headlight relay in 1992 Mazda Protege?"
Does a 1992 Mazda Protege have ABS?
No.
Can a single overhead head for a 1992 Mazda protege work can on a double overhead block for a 1992 Mazda protege?
DONT BE STUPID
How much should it cost to repair an alternator on a 1992 Mazda protege?
if the belt just coems of its should eb about $40 not including towing and that is on a manual transmission
Where is the fuel pump on a 1992 Mazda Protege?
In the gas tank.
Where's the block heater on a 1992 Mazda Protege?
My 92 Protege didn't have a block heater, I had to get one installed.
Where is the fuel filter located in a 1992 Mazda protege?
take out the flywheel and replace it with four banana peels, if this doesn't work take out the transmission and replace the fuel filter with a carton of milk.
What does a blinking Hold Light on a 1992 Mazda Protege mean?
tranny problems
Where is the Diagnostic port on a 1992 Mazda Protege?
Near the battery. It will have "DIAGNOSTIC" on the cover.
What is the tire size for a Mazda Protege?
for a 1992 it's 13" for a 1992 it's 13" P175/70/R13
On your 1992 Mazda Protege LX when the gas pedal is pressed all the way down it barely accelerates and stutters and when idleing the rpm needle shakes and sometimes it dies?
not my Mazda protege lx
