Ford Probe

How do you replace the alternator on a 1996 Ford Probe?


Top Answer
User Avatar
Wiki User
2015-02-14 23:37:24
2015-02-14 23:37:24

I have a 97 Ford probe and when I had to replace my alternator... I had to pulled the passenger tire off and pull the whole assembly apart so I could get the alternator.. There are 2 bolts to loosen up and pull the belt out slide the alternator down by the exhaust and pull it out by the CV axle


Related Questions

In the alternator. Have to replace the Alternator.

How do you change the alternator on a 1996 ford F350 diesel

the alternator is located on the passenger side of the motor towards the bottom front.

I had this problem what you need to do is remove the half shaft to get this out because there is no room to get it past this point. Sorry for the bad news.

Remove the alternator belt from your 1996 Ford Ranger alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.

How to replace alternator on a 2003, Ford F-350, 6.0 ltr.

steps to replace alternator on 2003 ford d150

Yes! The 1996 Ford Probe 2.0 is an Interference Engine. Serious engine damage will occur if the belt breaks. Replace the belt every 60,000 miles.

In the fuse panel in the engine compartment Relay # 21 is the fuel pump relay on a 1996 Ford Probe ( Helpfull )

how do you replace the alternator on a 2002 ford escape,without having to remove the the right side intermediate axle shaft?

Its on the top. Just some simple tools, remove the belt, and un-bolt. Its the easiest thing that Ford did with the car.

The voltage regulator is on the alternator. It is all one piece.

According to the 1996 Ford Probe Owner Guide : For the manual transaxle ( transmission ) ( Ford SAE 75W/90 gear oil , meeting Ford specification API GL-4 )

Are there any steps on how to change the alternator on a 1198 ford contour?

if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450

Yes , according to the Gates website the 2.0 liter 4 cylinder in a 1996 Ford Probe IS an interference engine

no it is not , your looking approx. 8.5 hrs in and out to replace a probe transmission....

no but if you can find an 88 to 92 tranny it will work fine

If you're mechanically inclined I recommend you buying a Chiltons or Haynes repair manual for the 1991 Ford Probe. Most provide the info on removing and reinstalling the starter. Also you might check your local library/s for these manuals. , EzForJesus the alternator is located behind the engine. the passenger side axle shaft must be removed in order to get the alternator out. make sure you disconnect the battery first.

how do I replace a parking lamp (left) on a 1996 Ford Taurus

You can restart the transmission computer, on your 1996 Ford, by removing the transmission, computer fuse. Keep the fuse out for 10 seconds and replace it to its original slot.

take off the drivers side tire, then the plastic splash gaurd. alternator will be right there

you buy one or take it to the shop

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.