Loosen the serpentine belt by removing one bolt and loosening the other on the belt tensioner located in the top middle of the belt position. Remove the serpentine belt from the alternator. Next remove the 3 bolts holding in the alternator and unplug the wiring harness attached. The alternator should now be able to come free with a little coaxing depending on its condition. Repeat in backwards order when installing a new alternator.
when should the vapor canister be replace on a 1996 pontiac sunfire
The labor to replace a clutch on a 1996 Pontiac Sunfire can range from $670 to $850, depending on where you go. This does not include the cost of the clutch itself, which is roughly $800.
A 1996 Pontiac Sunfire uses Dexcool coolant. This should only be mixed with distilled water, never tap water. Replace the coolant every 2 years or as needed.
WHERE is the timing mark on Pontiac sunfire 2.2l
If the part number is the same and the configuration is the same then sure.
how to remove key cylinder on 98 sunfire
I paid $3,500 for mine. Kelly Blue Book for a 1996 Pontiac Sunfire SE Coupe is $3,250.00 retail.
how to replace alternator on Toyota 4 runner 1996
I suggest picking up a Haynes or Chilton manual for your car and following their procedures.
thermostat? engine size?
remove both hoses and replace the o rings
I need to know where the fuel pump is located and how to get to it on a 1996 Pontiac sunfire gt
1996 pontiac sunfire 2.2 crank was moved but cam was not could the timing get out 180 degrees before i put it back together
A P1406 error code on a 1996 Pontiac Sunfire indicates a faulty EGR valve. This can result in poor engine performance and should be replaced immediately.
cavalier is basically the same
in the trunk or under your back seat
the drl relay is in the fuse box
The cooling system diagram for a 1996 Pontiac Sunfire can be found in its manuals. It can also be obtained as a print out at an auto part store.
I have a 1996 Sunfire and the 4way flasher is located on the top of the steering column.
take the wheel well out first then reach in and turn bulb socket
I'd suggest picking up a Haynes or Chilton manual for your car. It will take you step by step through the procedure.
Autozone.com has the diagrams you need