All you need to do is remove one long troq srew at the top of the brake assembly, and the whole thing will swing down pop the old pads out, compress the piston and pop the new ones in and just slide the whole thing back together. After a few times it only takes about 5 minutes, including taking the tire off.
The only part that is needed to replace your 1997 Pontiac rear brakes is a break assembly kit. The brake assembly kit will have everything you need.
Visit the forums at genvibe.com. There is a nice walk through with brakes to service your front brakes.
To replace the brakes, lift the car on a jack, remove the tire, brake shoe and old brake pad. Next put in the new brake pads, put the brake shoe and tire back on the car, and lower the car.
You will need to remove the tire and wheel from your 1998 Pontiac Grand Am. Remove the brake assembly spring from the brake pads. The brake pads will come off. Reverse the process to install the new brake pads.
Maintaining brakes on a vehicle is important for safety reasons. One must raise the car, remove the tire, the old brake pad, replace it with a new brake pad, make sure everything is where it needs to be, and then replace the tire.
pad brakes are disc brakes, it's known as changing brake pads for disc setup and changing brake shoes with drum brake setup.
One lifts the car on a car jack, removes the tires, remove the brake shoe, remove and replace the brake pad. Then one has to replace the brake shoe in the correct position, then put the tired back on the car.
how do you change a brake booster valve to a 1998 Pontiac transport
Remove the tire and wheel from your 2002 Pontiac Grand Prix. Remove the spring from the brake shoe. Remove the brake shoes. Reverse the process to install the new brakes.
To replace the rear brakes on a Volvo 850 you must first remove the old brakes. Then connect all of the wirings to the new brakes including the brake fluid line and the connection for the brake pads.
To thoroughly replace and repair brakes, one must replace the brake light wiring, brake pads, and brake calipers. Furthermore, one should reline the brakes.
when needing brakes do you have to replace the rotors to on a s60r
To replace the brake light on a 2000 Pontiac Montana open the trunk to reveal the housing units. Find the lights and pull the bulbs out. Replace the units.
To change the brakes a person lifts the car, removes the wheel, removes the brake shoe and the old brake pad. Next the person puts in a new brake pad, replace the brake shoe, replace the tire, and then lower the car.
1. replace brake pads.
Answering "How do you replace the brake pads on a 2004 Dodge Durango limited with anti lock brakes?"
To repair brakes, you need to first decide what needs to be replaced. You may want to replace just the brake pads, or the brake lines.
The brake caliber is sticking if it has rear disc brakes. The rear wheel cylinder is sticking if it has rear drum brakes. Replace both rear units and then drain all the old brake fluid out of the system and replace it with fresh fluid. Bleed the brake system.
The best place to have your brakes replaced at would be Midas they would be able to replace both your brake shoes and even brake calibers if they need replaced.
The emergency brakes are whatever your rear brake pads are.
Changing brakes is simple. Lift the car, remove the tire, remove the brake shoe, remove the old brake pad, replace it with a new brake pad, return the brake shoe, replace the wheel and lower the car.
Check the brake fluid...
Changing brakes is a simple task. Raise the car on a jack, remove the wheel, remove the brake shoe, remove the old brake pad, replace the brake pad, place the brake shoe back in the correct position, replace the wheel, and then lower the car.
how to change the brakes
what is the torque spec for a 2005 Pontiac G6 Gt brakes