Want this question answered?
pull or press the bearing out and take to a local bearing/machine shop to measure
Replace Angus cable craftsman 3.8 snowblower
Check your bearing on the shaft. Check pulleys for alignment also check bearing on idler clutch pulley.
if one shear pin has been sheared then just line up the auger shear pin holes the same as the opposite auger shear pin then tap out damaged pin.
if one shear pin has been sheared then just line up the auger shear pin holes the same as the opposite auger shear pin then tap out damaged pin.
MTD offers these 3 products for snowblower parts, the Auger Assembly Complete for $112. and the Spiral Crescent for $10. MTD also offers the Nut, Flange Lock for alittle over $2.00.
There are repair videos on the link below that will show you how to do it. Just copy and paste in your browser.
possible broken auger belt, or one that has slipped off the pulley
Got a toro 521 wont blow snow after 2 feet whats up
Jewel-Osco.
It depends on how it is bent. If it is just the flitting you can use a bar and a hammer. If it is the shaft you might be able to bend it back with a bar. If not you will have to replace it with new or used parts.
That means the auger is the only moving part that throws the snow. Two stage snowblowers have an auger to move the snow to the fast moving impeller.