answersLogoWhite

0

Just take the trim piece around it off and you'll be able to go from there. Just make sure you plug everything back in on the new one.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

How do you replace a blower motor resistor on 02 Chevy Prizm?

To replace the blower motor resistor on a 2002 Chevy Prizm, first disconnect the negative battery terminal to ensure safety. Remove the lower dashboard panel to access the resistor, which is typically located near the blower motor. Disconnect the wiring harness from the resistor, unscrew it from its mounting position, and replace it with the new resistor. Finally, reassemble the dashboard panel and reconnect the battery terminal.


How is the blower switch changed on a 1990 Geo Prizm with ac?

All you have to do is remove the trim piece from around the assembly. This will allow you access to the screws holding the switch in. Remove the screws, unplug the switch and take it out. Put the new one in.


Where is the oil pressure switch on a 1994 GEO Prizm?

where is located the oil pressure switch for 94 geo prizm


How do you replace headlamp dimmer switch on 1998 prizm?

To replace the headlamp dimmer switch on a 1998 Chevy Prizm, first disconnect the negative battery terminal to ensure safety. Remove the steering column cover by unscrewing the screws and gently prying it apart. Locate the dimmer switch, disconnect the wiring harness, and unscrew the switch from the column. Install the new switch by reversing the process, reconnecting the wiring, and reattaching the steering column cover.


Where is the Blower motor resistor pack on 1998 Chevrolet Prizm?

behind glovebox.


How do you replace the timing belt on a 1994 Geo Prizm 1.6?

How do you replace the timing belt on a 1994 Geo Prizm 1.6?


Why doesnt the low and med fan speed not work on your 2000 Chevy Prizm?

Your blower motor resister, which is a circuit card located in the bottom side of the blower housing ( just over your front passenger's toes ) is most likely partially cooked - replace it.


How do you replace the dome light on a 1995 Geo Prizm?

you pop the clear plastic off on the side of the swith and replace the light... close by putting the opposite end first and the clicking it in by the switch. thank you


How do you replace the blower resistor on a 2000 Chevy Prizm?

it is located under the dash behind the glove box. there are 2 bolts hold it in place. remove the wire connecter and the 2 bolts and slide it out.


How do you replace the water pump in a 93 geo prizm?

See the related question: How do I replace the water pump on a 1993 Geo Prizm 1.8L?


How do you replace the blower fan resistor on a 1998 Chevy Prizm?

it is located under the dash behind the glove box. there are 2 bolts hold it in place. remove the wire connecter and the 2 bolts and slide it out.


How do you replace a blower motor resistor pack on a 1999 prizm?

easy fix. 2 screws 1 wire connector. passanger side look straight up from floor unscrew it remove wire connector pull out and replace it took me about 5 minuits easy access