It is pretty simple, except for removing the old part, which is frustrating because of the location of the part with the pedals in your way and the small, difficult latches that connect the switch box to the wiring box. Be sure to have a few small flathead screwdrivers and inspect the new part prior to removing the old one. Locate the switch by starting at the brake pedal and running up the shaft until you see a tab coming off the left side. There should be a switch contacting the tab that comes from a small, tan box just on the aft side of the tab. Rotate the switch box a quarter turn and you should be able to remove the box by pulling it back from its metal support. Now it should be hanging by a group of wires. The top end with the wires coming out is the section the replacement switch plugs into. The switch box itself is L shaped (look at your replacement part first), and the latches that connect to switch to the wiring are on the lower left side of the L if you were looking at the box as it is installed before removal. The 3 latches to the connection box are green, and are difficult to depress, especially in the cramped area with the pedals in your way. I used a small screw driver to get under the switch box, and wiggled it over the latches until the box popped loose. Simply plug the new part in, press the brake pedal in fully and hold, insert the switch into the metal support by putting the switch itself through the round hole and fitting the square end at the base of the switch and turning the unit a quarter of a turn until it snaps in place. Release the brake pedal. Done.
== ==
The brake light switch, on a Dodge neon, can be found under the dashboard just below the steering column. The brake light switch just unplugs. Unplug the switch and replace with a new one.
A Dodge Stratus does not have a reset switch.
faulty brake light switch (on pedal)
the brake sensor for the 2001 dodge stratus is located on the inside of the car under the brake paddle.
Often these are accessed thru the trunk; have you tried that?
Where is the cool fan relay on a dodge stratus and how do you replace it
The brake light switch is on a bracket near the base of the steering column.
There is none as your Dodge is not equipped with an inertia switch.
How much should it cost to replace the airbags on a 1997 dodge stratus?
You put brake fluid in the brake fluid reservoir on a 1998 Dodge Stratus. This is located on the master cylinder, under the hood, on the driver's side.
A Dodge Stratus does not have an inertia or reset switch. The fuel pump is computer controlled with relays.