Open the glove box. Remove all items. There are two black pegs holding the glove box in place on the sides. Reach into the glove box and twist the pegs 90 degrees and wiggle them out. The glove box should drop down revealing the door for the cabin air filter to the upper left. Press the tabs on either side of the door and pull out. Slide the old cabin air filter and frame out. Replace the filter in the frame. Slide back in and replace the door. Close the glove box part way and reinsert the pegs. Twist 90 degrees in the opposite direction. Takes 5 minutes max. Great way to do it yourself and save.
1997 Toyota Camry does not have a cabin air filter. - It does not have an cabin filter, BUT the filter box is the same as the Lexus ES300 that HAS a cabin filter. BUT the 4th gen camry's had sealed the slot that had the cabin filter, Modifications is needed http://www.clublexus.com/forums/es300-and-es330/168680-es300-a-c-or-cabin-filter-change-97-01-a.html Same rules apply, except you need to cut where they sealed it up (will be covered by a cover*) *that you need to salvage off a 3rd gen camry or the ES300
The price for a used Lexus ES330 can vary depending on the condition of the vehicle. In general, a good price for a used Lexus ES330 will fall around the $12000 price range.
5
24F
32
don't they have differnet energy requirements and you can end up with dead batteries or worse 177
Pioneer is the manufacture.
Airbag. Off light
The brakes need to be replaced when they feel soft or show signs of enough wear during visual inspection to warrant replacement, the same as any car.
The 2005 Lexus ES330 uses the 3MZ-FE Toyota V6 engine, which has a timing belt.
any v-6 toyota camry from 1989 to 1999. also toyota pickup and tacoma (4 cyl) also toyota avalon, and lexus es300 and es330.
Open the hood. Look for the air filter assembly on the right just above the battery. Take a 9 mm socket and loosen the two bolts at the outside right edge of the air filter cover. Lift the cover gently and just enough to remove the air filter. Make sure you look at the orientation of the air filter so you can put the new one in the same way. Slip in the new filter. Place the cover snuggly over the filter and tighten the bolts. Total time 10 minutes most of it spent finding the right socket.