Just pull it out by the two slots under the vent ajusters.
How to install valve cover to a 97 Nissan maxima.
To change the trunk light in a 2002 Nissan Maxima, a person will need to unscrew the cover over the light. Then they can remove the old bulb and replace with a new one. Then screw the lens cover back on.
The rear wheel bearing, on a Nissan Maxima, can be removed by first removing the rear wheel. Next, remove the axle cover. Slide the wheel bearing off of the axle. Reverse the process to install the new wheel bearing.
I would like to know if you have to lift the engine up in order to change the sprokets on 2006 Nissan Maxima?
yes
The water pump is in behind your timing cover.
in the air filter cover
in front of your engine under your cam cover
The front wheel bearing on a 2001 Nissan Maxima is replaced by removing the wheel, prying off the bearing cover, and removing the retaining pin. The retaining nut can then be taken out, the calipers removed, and the rotor pulled to allow access to the bearing.
the pcv is located on the right top side of the valve cover. it has a hose connected directly to the crankcase cover.(on my car the cover is red)it is simple to replace and costs dirt cheap.NEVER open the hose and take off the pcv when hot. use a wescott for simplicity. specs for 1992 Nissan maxima se, single overhead cam, probably the same,different pcv for dohc though.
How do you replace a broken tail light cover for a 2005 Nissan Pathfinder ?
The PVC valve on a 1999 Maxima is located in the rear valve cover just behind the throttle body.