remove the nearside driveshaft & and just pull the box asside thus giving u plenty of room to renew the clutch with it sitting on the subframe. hope this helps. remove the nearside driveshaft & and just pull the box asside thus giving u plenty of room to renew the clutch with it sitting on the subframe. hope this helps.
how do I bleed water system on the 806 peugeot
How do you change fuel filter on peugeot 806 diesel?
Actually there are several different models of the Peugeot 806. The petrol ones are: Peugeot 806 2.0 (here we have two different ones: first one was built from 1994 - 1998 and second one was built from 1998 - 2002) , Peugeot 806 2.0 16V, Peugeot 806 2.0 Turbo (here we have two different ones: first one was built from 1994 - 1998 and second one was built from 1998 - 2002) and finally the Peugeot 806 1.8.
To replace wheel bearing on a Peugeot 806, loosen lug nuts and jack the vehicle. Remove lug nuts, the wheel, brake caliper, dust cover, cotter pin, castle nut, and rotor. Unscrew hub nuts of the wheel bearing and replace with new.
I have been looking for a replacement gearbox for my 2000HDi, found that the 1.9 will not fit.
it is impossible
Your peugeot 806 heater only gives cold airRead more: Your_peugeot_806_heater_only_gives_cold_air_ou
dont buy a peugeot
if its the same as a ulysse,its behind the glovebox!
It is on the end of the light stork, just press it...
To keep a car running smoothly, the correct fluids must be maintained in the vehicle. 78W-80 mineral oil should be used in the Peugeot 806 Gearbox.
where does the clutch cable go from the pedal?? my clutch snapped earlier
Auto repairs are a skill that requires education, time, and patience. If you are not licensed, you should allow a professional to replace your clutch to prevent any damage. .
the clutch cable on my peugeot partner van has detached itself from the pedal.How do i go about changing the cabel?
far right hand side above the accelerator
On a Peugeot 806 car stereo there are two thin pieces of black plastic at each side, you need to gently prize them off, and that reveals 2 screws on each side you can then remove the stereo. -Jakey5565
The clutch cable on a Peugeot 206 is self-adjusting. If it is not working right, then there is something broken. The auto adjuster is part of the clutch cable assembly, so a new clutch cable is required.
Fault with clutch master cylinder.
Behind the glove box. Just remove it and you'll see it
How do you replace the spark plugs on a Peugeot 307?
How do you replace peugeot 407 serprntine belt
Replace clutch cable on sportsbike
Remove the radio retaining cover. Remove the radio retaining bolts. Remove the wiring harness and the antenna cable from the back of the radio. Reverse the process to install the new radio.