you cannot just change the boot you will have to replace the whole axle
i was wondering how to fix a Nissan sentra 1996 1.6 c.v boot just some instructions.
CV boot? Tierod boot? Ball joint boot? Driveshaft slip yoke boot? If its torn REPLACE it
Sparks plugs are replaced by disconnecting the battery, removing the spark plug cable and boot, and by removing the old spark plug. Next put in the new spark plug, attach the boot and cable and reconnect the battery.
the boot you can tell with a visual inspection. there should be no tears in the boot. the boot is there to keep grease in and debris out. if the boot is torn and most of the grease is gone you probably should replace the shaft. if you catch it soon enough though you can just replace the boot which is much cheaper.
lift the boot, and grab a screw driver and unscrew the light and then at the back of the light twist the bulb out and replace and twist it back in afterwards.
remove the console, you should see some screws on the bottom of the boot, remove, replace boot, replace console
To replace the shifter boot on a 2001 Nissan Maxima SE, first, remove the center console by unscrewing any visible screws and gently prying it up. Once the console is removed, disconnect the old shifter boot by pulling it off the shifter and detaching any clips or fasteners. Install the new boot by sliding it onto the shifter and securing it in place, then reassemble the center console by reversing the removal process. Ensure everything is properly aligned and secured before finishing.
A CV boot is found on the axle of a vehicle. To replace the outer boot remove the axle bolt and pull the boot off. The inner boot requires removal of the whole axle.
take off bolts you can get to them from boot take off bolts you can get to them from boot
I am having the axel changed not one boot...and the mechanic quoted me $150 which includes parts and labor.
Get a new key or get a hammer and smash the boot open.
12 inches