you have to take off the dash board panels. these screws will be over the radio, behind the ashtray, under dashboard over the gauges, and the last set will be on each side of the steering wheel. u can then see the 4 screws for the gauges and just remove screws, reach back and twist bulb out. i would suggest changing all four at the same time because if one goes out they all will. i learned the hard way
Is that the only thing not working? check your tail lights. you will still have brake lights but if you blew a fuse your running lights , tail lights and dash are all on the same fuse. mine kept blowing it was a bad ground by the alternator.
that depends on the model year of the rodeo. If its a 92/93/94 remove the guage housing module(see how do i remove the dash board of a 93 rodeo) Once the module is out the front and rear panels of it will pop off with a screwdriver and you can replace the bulbs.
2004 3.5 Isuzu rodeo 2wd reduce power light
The check trans light may light up in an Isuzu Rodeo, because there are problems with the transmission, The light will show up on the cars dashboard.
The four wheel drive light is most Likely staying on when your Isuzu Rodeo is in two wheel drive because of a bad sensor. A licensed auto technician would be able to replace this for you.
The oil light could be blinking in an Isuzu Rodeo because it is time to get the oil changed. This could also occur if the oil is low.
4x4 indicator light
If its the bulb you have to unscrew the light cover and pull out the old bulb and put the new one in.Then screw the cover back on.
1157
disconnect the battery
My check engine light has been on for one month but last night my check trans light flashed off and on about 3miles till I was home. Why and what do I need to do? I have a 2000 Isuzu rodeo.
open the hood unplug the bulb from the back of the light assembly and un do the metal clip, pull bulb out of replace with a new one and reinstall
sending unit in tank