DICE UNIT REPLACEMENT [93 03-07]STEP 1 Remove the driver side kick panelSTEP 2 Remove the air ductSTEP 3 Remove the screw that holds the relay panel holder and move holder out of the waySTEP 4 Remvoe the screws that hold the dice unit and remove the unitSTEP 5 Refit in reverse
Its built into the radio unit with dice part of alarm system di (dash intergrated) tw (theft warning) and then ice (radio)
Well you really can't on your car. All they keys are programmed in to what's called the dice unit, which is in turn spider webbed into the rest of the cars systems. The dice unit would need to be bypassed/flashed and after market parts to duplicate/repeated a key signal would be needed. And that would just be the electronics side. Have a licensed/bonded/insured saab specialist in your are re-key and program the dice . ~Warning~ 99% of people out side a deal who claim they can flash the ecm or reprogram the dice etc can not. To do it right where it won't trash that very temperamental saab. Its 1000s in tools and software you can't even find stateside, takes hours of trial and error ( unless you a dealer )and for every one I have done I have cooked/bricked at least two.
um that is hard to say
Remove the gasoline from the gasoline tank. Remove the fuel line from the gasoline tank. Remove the fuel sending unit retaining plate. Reverse the process to install the new fuel sending unit.
The oil sending unit for a 1998 Buick Ultra is located on the front of the engine, below the power steering unit. Remove the plug from the sensor, and unscrew it from the block to remove and replace it.
The fuel tank has to be removed to gain access to the fuel sending unit. The fuel sending unit and the fuel pump is replaced as a unit.
THERE SHOULD BE AN ACESS HOLE IN THE TRUNK TO GET TO THE FUEL PUMP THAT IS LOCATED IN THE TRUNK.REMOVE FUEL PUMP AND REPLACE WITH NEW PUMP.
In cm squared
In the gas tank.
Underneath the front passenger seat.
The Hydraulic clutch fitted to the rover 400 is a sealed unit and the only thing that you can do is to replace the complete unit
You may use millimeters.