0
How do you replace the distant sensor on 1991 Plymouth acclaim?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is a 1992 Plymouth acclaim crank sensor?
No crank sensor. Only has the distributor pick up plate.
Where is the crankshaft position sensor in a 1990 Plymouth acclaim located?
It doesn't have a crank sensor. It only has a distributor pick up plate (cam sensor).
Where is the MAF sensor on a 1993 Plymouth Voyager and is it difficult to replace?
A Plymouth Voyager does not have a maf sensor.
Where is the O2 sensor on a 1990 Plymouth Acclaim 3.0 liter 6cyl?
It is screwed into the exhaust behind the engine.
Where is the O2 sensor on a 1990 Plymouth Acclaim?
The sensor is between the cab and engine. its in the back of the engine not the front like many other vechiles.
Where is the cps on a 1990 Plymouth acclaim 3.0l?
The cam position sensor is inside the distributor, under the cap and rotor. There isn't a crank sensor.
Where is the oxygen sensor located on a 1994 Plymouth Acclaim?
the oxygen sensor in located in the exhaust manifold under the intake manifold at the back of the engine
How do you replace the camshaft position sensor on a 1997 Plymouth voyager 3 L?
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
Where does a Automotive Throttle Position Sensor go in a 1995 plymouth acclaim?
On the throttle body opposite of where the cables attach.
Where is the 91 Plymouth Acclaim speed sensor?
it is on the back of the transaxle of the transmission its an oval piece with a two part wire going into it.
Where is the speed sensor on a 1991 Plymouth Acclaim located?
I have a 1992 acclaim, the speed sensor is located on the right hand (passenger) axle. Look on the back side of the axle,about 6 " down from the transmission, you see a lump on the housing, with 2 or3 wires leaving the top.
Where is the 92 Plymouth Acclaim speed sensor?
It is located on the backside of the engine/transmssion assembly against the firewall. It is screwed into the diff houing and is easier to get to from beneath the car.
