How do you replace the distributor on a 1997 Ford Laser Tracer F6 engine?
Ford Laser 1990 model that will drive fine than all of a sudden it stops than it wont start again than a day later it starts up again you checked for spark and there wasnt any?
hai iam manu i haVE A ford laser gl 1992 model in 1990 model for laser engine is different from that of 1992 gl model its engine is quite new the engine is mazda b platform engine with 16 valves but the old engine has only 8 valves so that the performance figure is different compared to the old drivetrain has also been immproved simultaniously a lpt. they are different series engine no similarities
If you can no longer adjust them to the required gap and still have them separate far enough in between. They are so cheap if in doubt just replace them, I got tired of messing with them and bought an Accel laser distributor made of billet aluminum, problem solved forever. simle test match book cover between points adjust; won;t start replace 65
Well, I know how, but it's not a good idea as it will make the laser produce more ir radiation, which is not good for you at all. I recomend buying a new laser. techlasers.com is the best, i just bought the 125mW infiniti, and its amazing. Also,you can replace laser diodes inside the red laser pointer,laser diodes are available on freaklasers.com
Will a 2.5 liter L4 engine out of a 1994 Dodge spirit work in a 1986 Chrysler Laser which had a 2.2 L4?
The list of weapons that start with laser are: Laser axe Laser bow Laser chaingun Laser chainsaw Laser cannon Laser crossbow Laser daggers Laser gatling gun Laser knife Laser machete Laser machine gun Laser rapier Laser rocket launcher Laser scythe Laser shotgun Laser slingshot Laser sword Laser tommy gun Laser whip and countless others
The module is in the distributor. You have to dismantle the dissy to replace. The module is conected to a small coil by push in clips. The coil sits around the center spindle and the module is held by 2 screws. White heat sink grease is supplied with the new mod. and is applied to the back before screwing down. The wires then clip on to the module. Usually when gone, the car stops and…