Nissan Trucks and SUVs
Ford Explorer XLT
Ford Ranger XLT
DIY Projects

How do you replace the door lock on a 1995 Nissan Pickup?

767778

Top Answer
User Avatar
Wiki User
2007-02-19 19:05:45
2007-02-19 19:05:45

Your best bet is to buy a owners workshop manual It shows all the steps to remove it and install it.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The way to replace a door handle on a Nissan pickup truck can vary depending on the year of the truck. There are several tutorials available online.

User Avatar

You can use parts off a 1987-1995 Nissan pathfinder. 2 or 4 door will work just fine. Rule of thumb, a 2 door pathfinder is based on a regular cab pickup chassis, a 4 door pathfinder is based on a king cab chassis.

User Avatar

remove door panel, roll down window 1/3, unbolt from track

User Avatar

Look at the handle closely and on both edges you need to pop the covers off. After that you just take the 2 screw out and replace.

User Avatar

remove front door panel 1995 Nissan maxima

User Avatar

Have to remove the door, then remove pins and bushings

User Avatar

I have a 2001 Nissan quest,recently my door locks are malfunction,when I pull the door in it locks,when key in ignition it locks,what cause this problem?

User Avatar

how do you replace the drivers window clips on the glass od a 1995 grand prix se 2 door?

User Avatar

go to auto parts store and purchase a haynes repair manual

User Avatar

On my 1993 Nissan pickup the Fuel Filter is under the hood. Facing the truck ( passenger door left, driver side to the right) It was to the left of the air filter. Cost about 15.00 at Advanced Auto. Took 15 mins to replace. Be sure to unhook battery, its not from it. Look under and near power steering unit.

User Avatar

I would find a replacement in a salvage yard and replace the handle. Or replace with door poppers

User Avatar

Inside the frame rail, driver's side, almost even with the door.

User Avatar

How do you replace the panels on the outside of a 1995 pontiac Grand am?

User Avatar

you must pull inner door panel, window crank and inner handle then you have two 10 mm nuts holding outer door hanle on you must remove the release rod from handle remove nuts and replace handle assemble in reverse order

User Avatar

If the door is hangging low and hard to close. You will need to replace the door bushings, once the they wear out the door is allowed to sag. Hope the answered your question.

User Avatar

Theres a switch/lever you push down on. Its located on the floor near the driver side door.

User Avatar

4 inch on door panels and 5 1/2 in the back wall

User Avatar

check the driver side door jam, factory spec, 195/75R14 for a 14.5 rim

User Avatar

how to replace a blown bulb behine my 99 quest speedometer


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.