Hard Job---TAke the trim panel off by removing the door handle then all screws you can find then the retainers around the sides and bottom of the door. The reetainers require a special tool. Be careful as there are sharp edges that can cut you BAD inside the door. Also there is spring tension on the window regulator.
How to replace a window and regulator on a 1998 checy malibu?
Replacing 2002 Dodge power window motor driver side
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
You need to replace the power window regulator. Go to 1aauto.com and search for the video showing you how to do this.
Must replace window regulatorhttp://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-motor-regulator
video on how to replace window lift motor on j30
I would try the window switch first , but if you are going to replace the switch then you will see how to replace the motor. You would have to take the door panel apart after that its easy.
Just use a flat head screw driver to pry it off.
Very difficult. I would leave it to a glass shop.
it's riveted in. I drove around for years with a broken drivers side window motor... The cheapest way to fix the problem is to get a new door......Promise. Shops were saying nearly $700 to replace the motor.....
There are a couple of reasons why a window won't go up on a 1998 Malibu. The window may be off track or the window motor has stopped working.
How to remove the window motor from the regulator
replace a window lift motor for a 2002 gmc sierra?
replace 1987 dodge pickup/power window motor
when replacing motor what position does the window need to be in?
don't just replace the window motor replace the whole car. get a hybrid or something
How to replace a motor driver side for a town and country 2002
The motor could be burnt out on the window. This is more than likely what has happened. The motor can be replace for a low cost.
You need to replace the window motor relay. I've had all 4 window motor relays replaced 3 times each and the driver side replaced 4 times. Seems like a poor design or poor OEM quality.
pull off the door panel, and the will be some plastic, pull that off and you will see the bolts holding the motor on the door, watch how you pull it off and remember how it go's back in, shouldn't take you more then 20-45 mins to pull it and replace it
HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW
power window motor removal 93 sunbird