It's located behind the glove box. First, remove the negative battery cable from the battery. Remove the glove box door. There are four 10mm nuts that mount the ECM to a plastic bracket....one at each corner. Remove these. Pull the ECM out and unplug it. There is a cover plate on the ECM mounted with two screws. Remove these screws and remove the plate. The PROM chip is mounted here and you'll want to reuse it. Most rebuilt ECMs will not come with this chip. Also, each chip is programmed for the particular car it goes in. With or without air, auto or manual....etc. Install the chip in the new ECM and the rest is reverse procedure.
ecm and ing. module
1992 sunbird is obd1,1996 firebird is obd2.Will not work.
The ECM is located behind the glove box. Remove the glove box door. You'll see the ECM. Disconnect the battery. Remove the three plugs on the bottom of the ECM. There are 4 nuts that hold the ECM in. They are 10mm. Remove them and pull out the ECM. Install is just the reversal. Remember to take your PROM from the old ECM and put it in the new one. New ones don't come with the PROM and it's highly probable that a used one will have the wrong PROM installed as each one is programmed to each specific car.
Try taking your positive battery cable off for 3mins or taking out the ecm fuse in the fuse box for 30 seconds.
replace the ecm
The ECM is located on the driver's side, under the hood on a 2003 Pontiac Montana. It is on the driver's inner fender.
Defective Coil pack, defective spark wires, plugs. Bad ground(s). Open (electrical short) in starting system. Faulty Ignition switch, ECM, other.
you can't fix an ecm, you have to replace it.
no
Bad Ignition (Spark Plug) Wires. Bad Coil(s). Bad ECM or ECU. Incorrect Spark Plugs. Ground Wire(s) missing or loose. Alternator fault. Bad Battery.
The ECM on a 1998 Pontiac Transport with the 3.4 V6 engine is located on the passenger side. It is behind the glove box.
The ecm is located behind the "glove box", in the center console between the seats.