0
There are four bolts that hold the headlight assembly into place on 900s from 1987-93. There are two (2) on top, one (1) at the bottom at a right angle to the top two, and (1) one that connects the headlamp assembly to the turn signal assembly. I believe all are 10mm head and bolt size.
What else can I help you with?
How do you replace the motor mounts in an 1989 Volvo 240?
Easiest thing to do is lift the motor about 4" with a hoist, removing the entire mount bracket on both motor AND the Rack. Replace the mount without the brackets mounted, and install the entire assembly as one piece
How do you replace a headlamp on a 1999 Honda Accord LXI?
There was not a 1999 Honda Accord LXi made. Do you have a 1989 Honda Accord LXi?
How do you replace the front turn signal bulb located on a 1989 Buick Regal?
you have to remove the entire head-light/turn-signal assembly to get to the bulbs. There are these plastic clips on either side of the ENTIRE asembly, just pull them up and the entire assembly comes free. Remove the rubber stoppers on the back and then you need to twist the bulb housing to remove it from the asembly. The bulbs themselves just pull out.
Is it possible to replace the water pump seals on a 1989 Jeep Wrangler or do you have to replace the entire water pump?
Replace water pump and gasket
How to replace bearing hub assembly on 1989 blazer?
Buy a Haynes Manual or similar OR take it to a mechanic :-)
What needs to be removed to replace a 1989 Chrysler New Yorker Heater Core?
The entire dash and the HVAC housing.
How do you replace the headlight assembly located on a 1989 Ford Fairmont?
remove the screws holding the ring around the light then remove the light.
How do you replace the rear turn signal bulb located on a 1989 Buick Park Ave?
Open the trunk and pull the upholstery away from the rear of the inside of the trunk. You will find white and black plastic wing bolts that hold the tail light assembly in place. The white ones retain the lens assembly for that side only, while the black ones retain the entire full width assembly. The factory made the lenses so that they will swing up for light replacement, that is if you like to stand on your head. It is easier to remove all of the wing nuts and pull the entire assembly away from the car. Jack
How do you replace fuel pump in my 1989 Chevy k5 blazer?
drop tank take pump assembly out of tank,unplug wires and repeat in reverse for install
1989 cutslas and the power antenna motor keeps running and the antenna is stuck in the up position What do you do?
If the antenna is in the up position, you have 2 options, replace the entire assembly, or unplug it. In the trunk under the antenna, you will find a set of 3 wires going into a relay. Unplug those, and the motor will turn off.
When did Campaign for a Scottish Assembly end?
Campaign for a Scottish Assembly ended in 1989.
When did Great National Assembly end?
Great National Assembly ended in 1989.
