* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car
How_do_you_remove_a_door_panel_and_handle_to_repair_the_window_in_a_'00_Hyundai_Elantrathis might help..
take it out
Could be the overdrive on/off switch, which is located on the gearshift handle. That's all the help I can give you, best of luck.
The interior door handle on a Hyundai latches onto the locking mechanism of the door. First remove the old handle by unscrewing it from the door panel. Pull the handle out and remove the locking wire. Install the new unit with the locking mechanism in place. Tighten the mounting screw.
The 2003 Hyundai Tiburon has door handles that sometimes break or need replaced. They can be easily removed and replaced with a new part.
* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car
1. Raise the window and remove the door trim panel and water shield 2. Working through the access hole disengage the plastic clips that secure the outside handle-to-latch actuating rod and the outside door lock-to-latch actuating rod 3.working through access hole remove the outside door handle retaining bolts 4. Remove the handle/lock cylinder assembly from the vehicle
Make your life easy and just break off the door handle. When you are finished with your project, just replace the door handle with a new one from the dealer.
I have read that you need a "powered" wiring harness because the Elantra routes the tail lights through a computer that cannot handle the extra amperage necessary to drive a trailer's lights. A powered harness connects directly to the battery for power and taps the tail-light wires to control relays.
what year? i have a 2007 and I'm trying to find out the same thing. I know there's a screw hiding under a cap in door handle, then the bottom will pry outeard. Not sure about the top half though
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
Take it to a dealer