I seriously suggest buying a haynes or chiltons manual!This will give a step by step process and some pictures for illustration.Tools you will need are a C clamp to push the piston back in on the caliper,open end wrenchs and rachet and sockets.I suggest buying some caliper bolt grease for the slide pins,and brake quiet that is applied to the back side of the brake pads(the part that the caliper rest on).If do this your rotors may need to be replaced due to age/wear.I suggest buying new rotors!! it is only 20.00 per rotor and cheaper than most shops charge to machine the originals.I could write more but,this should give you the general idea.If you have to replace the rotors(suggest doing this) due to the rotors can damage the new brake pads due to the rotor wear cuts grooves into the rotors and will wear out new pads prematurely.
If there is no brake lights on a 1998 Mazda pickup, check the fuse. If the fuse has blown, the lights will not work.
use brake fluid
How to Install Front Brake Pads Check Related links below.
DOT 3 Brake Fluid
replace it
I assume you are asking about the brake pedal. Might be due to low/no brake fluid in the reservoir, air in the brake line, possible leak in the brake line, or the master cylinder may not be working properly,
which one the center or the side?
Replace Alternator
I am looking for the bulb number to replace a burnt out bulb on a 1991 Toyota pickup
disconnect it from your brake pedal lever.
Lift the car on a vehicle jack, remove the tire, remove the brake shoe/caliper and remove the old brake pads. Put in the new brake pads, replace the brake shoe/caliper, replace the tire and lower the car to the ground.
change stop brake light under foot pedal check fuses first