Is it just the bulb? Or the whole thing?
There is a Philips-head screw holding the corner marker in place. It is easily seen from above when the hood is opened. Remove the screw. Gently pry between the body (use towel to prevent scratching) and the corner marker housing assembly. The assembly will need to move directly forward. Other than the screw just removed, there is one metal pin and 3 plastic pins holding it in place. The metal one has a tendancy to stick with time.
If the assembly doesn't come out, it's because of this metal pin. The pin is located at the very front very bottom of the assembly. To reach it, slide a screwdriver just behind where the corner light and headlight assemblies meet. The pin fits into a white socket that will look like a white ring - slide the screwdriver blade in front of the white ring to pry the pin loose.
Bulbs are replaced by turning the bulb holder 1/4 turn and pulling out of the back of the housing. For ease of bulb replacement, you can unplug the bulb holders, as well.
This procedure also works for the 1994 Honda Accord (and possibly for the 1995 1996 and 1997 Accords).
This is how I did it...
Remove the plastic plate just under the front turn signal... Lay on your back and scoot directly under neath looking up through some styro foam and you will see a screw that is encased in a plastic sheath... This prevents the screw from falling out... unscrew it and wha la... the turn signal comes right out.
There is a screw on the side of the signal, you can reach it through the middle of the bumper. unscrew that and the whole signal will come out of the bumper. pop the clips and then the lens will come off
I need to replace the bumper cover on a Honda accord 98 EX 4door. is there a site where the screws and pags are?
If its for the 90s models its just a screw in the inner side of the light housing on the bumper. See sources and related links below for bulb information.
It is about $300 to $350 in Flushing NY
This video on YouTube (see Related Links) will show you how to remove the front bumper cover from of a 2004-2007 Honda Accord.
I just changed mine....I have 2001 Honda Accord (EX-V-6) and the local guy charged me $500. Good Luck!!
If a turn signal does not blink on a 1996 Honda Accord that it is time for it to be changed. To change the bulb and locate the light housing and remove the older light. Replace the light.
How do you replace a radiator on a 1991 Honda Accord
how do you replace the radiator on a 2003 V6 Honda Accord
1st take off the screws then he old bumper...put the new one in and the return all the screws. EASY!!!
To replace the light, it all depends on the year of the Accord. I have a 5th gen(94-97), and I know how to replace the 4th gen(90-93)
behind the bumper
yes along with the headlight
To install a rear bumper on a 1999 Honda Accord place all the mount clips in the appropriate brackets. Clip on the bumper then proceed to screws in the hardware in the correct mounting locations.
There was not a 1999 Honda Accord LXi made. Do you have a 1989 Honda Accord LXi?
A 2004 Honda rear bumper cover can be made to fit a 2007 Honda Accord. However, the amount of helper parts to make this fit happen will cost more in the end than it would to have just bought the bumper outright.
how to install and replace a rack and pinion on Honda accord 1994 lx
the car with an H in the middle of the hood and/or trunk and says accord above the rear bumper
How to replace a timing belt on Honda accord 94
How do you install a turn signal switch in a four door 1993 Honda Accord
I have the replacement part and it has a screw that can be reached through the front bumper opening, but the screw doesn't come out. Seems like there's another one that can't be seen, or a clip that holding it in.