One way of doing this is from under the front fender. Locate the seam in the deflector panels under the fender. You can remove several of the clips or screws (I don't remember which they are) and slide your hand and arm up toward the light between the panels. You can unscrew the bulb, pull it out and put in another. You may have to work simultaneously from the engine compartment to assist in this process. It may help to have another working with you. It is kind of hard but it can be done.
When replacing the rear turn signal on a 1999 Acura Integra open the trunk. Locate the rear turn signal housings and find the bulbs. Remove and replace the bulbs.
how do you replace front left turn signal on a 2001, volvo, s80
The turn signal bulbs on a 1999 Acura TL are reach through the engine compartment of the car. Find them on the side quarter panels and remove the bulbs from the clips. Replace the bulbs.
how do u change front signal lights for corvette 1999
Simply by removing the front signal lense, First pop the hood open. Secondly, locate the front signal lense. Third, their is a screw on the top of the lense, unscrew it, pull the lense toward the front, than twist the light socket, replace the bulb. For reinstallion just work backwards. Good luck :)
how do i replace the front strut on 1999 Saab 9-3
To change a headlight on a 1999 Acura TL open the hood and locate the bulbs which are plugged into the housings. Loosen the bulbs and pull them off. Replace them.
How do you replace the front wheel bearings on a nissan frontier 4x4 1999
To change the front signal light bulb on the 1999 Honda CRV, pry up the fender fastener to expose the bulb socket. Twist the bulb socket 90 degrees and remove from the assembly. Turn the burnt bulb counterclockwise and pull out. Replace with new bulb.
how to replace a exterior front door handle on a 1999 toyota tacoma
Turn signal lever assembly can be replaced without removing the steering wheel. See instructions at the attached link question about replacing the headlight switch on a 1999 Subaru Forester.
you have to remove the whole headlamp assembly to get to the turn signal bulb pull the headlight assembly straight out it is fairly easy There are two wing nuts on top of the unit that must be removed.