How do you replace the fuel filter located on a 1995 GMC Sonoma?

Answer 1

I take the old filter out with the ring still attached and after measuring the location of it on the old filter I carefully tap that ring off. Measure the location on the fne filter and slide the ring back on tapping it carefully to the same location as on the old filter. Then reinstall the filter sliding the lines into each end and then attach the ring to the frame with the bolt, tighten the fitting on each line, start the vehicle and check for leaks.

The fuel filter is attached to the frame of the truck right below the door post of the driver side door. It is an in-line filter and is held on by a plastic strap that holds the filter as well as the return fuel line to the gas tank and (I believe) the brake lines that go to the rear wheels. I was not able to slide the old fuel filter out of the plastic clamp when I tried to change the filter, but there may be a trick that I don't know about. Anyone else know how to slide the filter out of the plastic clamp?

• On a 1995 GMC Sonoma the fuel filter is located below the drivers seat and is attached to the mainframe via a plastic clamp. The fuel lines may have pressure, use caution when disconnecting. The fuel lines provide some flexibility and will allow the filter to go in and of the the plactic clamp. In addition, the fuel lines will determine the alignment of the filter above and beyond the ability of the plastic clamp.