Safety recomendation: Disconnect battery before proceeding. On all C/K's of this body-type 88-98, the fuel filter is located under the driver's side door inside the frame rail near the crossmember that supports the tail of the transmission. Replace it with AC Delco part GF-626, FRAM part G3727, or other comparable brand corresponding metal bodied filter. You should use a flare-nut wrench for the line fitting and one for the filter fitting. I'm not sure of the size needed for the filter, but the line should be 5/8". For SFI engines ('96 and later) you need to bleed off the pressure in the line. Locate the pressure test port on the fuel rail under the hood, remove the cap, press valve to relieve line pressure and recap valve. If ground clearance is not high enough to get under vehicle and work, raise it with jack and rest frame on jackstands. *Caution: Fuel in lines and filter will run out once fittings are undone. Use fuel safe container to catch fuel spill. Take wrenches and hold filter from rotating, while loosening line fittings. Remove Filter from bracket by sliding and manipulating fuel lines for clearance, and slide filter out of bracket. Reassembly is reverse of disassembly. Tighten fittings snugly. Reconnect battery, turn ignition on (do not start). Pump will make brief whirring sound - less than 5 seconds. Check for leaks. No leaks - good. Now you can drive again. Hope that helps.
drop pan replace filter reinstall pan
Replace it every 75,000 miles.
The 2003 Chevrolet Suburban fuel filter is located inside of the gas tank. You will to remove the gas tank in order to change the fuel filter.
In 2005 Chevy started putting the fuel filter inside of the fuel tank.
It is inside of the fuel tank.
Under the vehicle, behind the driver.
On the engine block. where on engine block?
It is located on the driver side. Right below the second door.
How do you replace a starter in a 1999 suburban
You will have to remove the pan on the bottom of the TRANSMISSION, and you will see it.
under drivers side inside frame rail
The filter is on the drivers side frame rail close to where the rear of the torsion arm is located.