answersLogoWhite

0


Best Answer
Copy

BIG===BIG JOB I suggest taking it to the garage as it will take a backyard mechanic weeks to do.

Replacing the head gasket on any vehicle is a long and complicatedprocess, however if you wish to see basic step-by-step instructions goto the related question on the right side of the page"How do you replace a head gasket?"

User Avatar

Wiki User

โˆ™ 2015-07-15 21:46:58
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you replace the head gasket located on a Nissan 300ZX?
Write your answer...
Submit

Related Questions

How do you replace strut and coil spring on Nissan 300zx?

replace coil springs in a nissan 300zx


How do you replace multifunction switch on a Nissan 300zx?

i have a 300zx Nissan and i need to replace themultifunction switch i don't know how?


How do you replace the oil pan gasket on a Nissan 300zx?

http://www.300zx-twinturbo.com/cgi-bin/manual.cgi Check out this link. I use this for everything when I work on my 300zx. This exact link will take you right to the section that gives step by step instructions on how to replace the oil pan gasket. Good Luck


How do you replace a head gasket on a 1985 Nissan 300zx?

The intake and exhaust manifolds, along with the timing belt will have to be removed to gain access to the head. Remove the head and replace the gasket. Torque the bolts down to the manufacturer specs and in the order Nissan suggests.


Where is the control module located on a 1987 Nissan 300zx?

Where is the ignition control module on a 1987 nissan 300zx


Where is the inhibitor switch on a 1990 Nissan 300zx?

it is located on the transmission itself


Where is the bleeder valve for fuel injection for 1986 Nissan 300ZX?

The bleeder valve for fuel injection for 1986 Nissan 300ZX is located at the furthest end of the fuel rail.


Where is the solenoid on a Nissan automatic transmission located?

First, what year and car are you asking about? 1987 Nissan 300zx


My air conditon blower don't run on your 85 Nissan 300zx?

ok....replace it


1984 Nissan 300zx have power to coil but no spark?

your coil is bad replace with new on


What are the Nissan 300zx production numbers?

There were 3,000 Nissan 300zx convertibles made


What motor is in the Nissan 300zx?

VG30DETT is in the 90-95 Nissan 300zx. It is a v6


Where is the thermostat located on a 1992 Nissan 300zx non turbo?

water pump


Where is fuel pump located on a 1996 Nissan 300ZX?

conniaute lake, PA


Where is located air filter in Nissan 300zx?

its under the pannel in between the headlights


Where is the oil dipstick located on a 1986 Nissan 300ZX?

Drivers side of the car it is located in the center of the motor.


Will a 1984 Nissan 300zx engine and transmission bolt into the 1986 Nissan 300zx?

Yes it will


Will a 1986 Nissan 300ZX T Top fit a 1985 Nissan 300ZX?

yes!


How do you replace thethemostat on the Nissan 300zx?

You'll have to take off the water pump because that is where the thermostat is.


How do you install a thermostat on a 1987 Nissan 300ZX?

To install a thermostat on a 1987 Nissan 300ZX, remove the two nuts and one bolt on the lower water neck. Slip off the old thermostat and use a gasket sealant to secure the new thermostat.


Where is Heater blower motor located in 1996 300ZX Nissan?

under passenger side


Your Nissan 1991 Nissan 300zx twin turbo wont start?

no power to starter on Nissan 300zx twin turbo


Will a 1987 Nissan 300zx head work on a 1988 Nissan 300zx?

If they both have the same engine.


Where is the ignition switch located on a 1986 Nissan 300ZX?

when you start the car up that's your ignition switch is located...


Where is the washer reservoir 1991 300zx?

The windshield washer reservoir in a Nissan 300zx is located behind the rear left trunk panel inside the trunk. This is where it is located in my twin turbo anyways.