0
What else can I help you with?
How do you replace strut and coil spring on Nissan 300zx?
replace coil springs in a nissan 300zx
How do you bypass the neutral safety switch on a 1988 Nissan 300zx using a jumper wire?
dont....just replace it..its safer........
How do you repair light switch for 1985 Nissan 300zx?
To repair the light switch on a 1985 Nissan 300ZX, first disconnect the battery to ensure safety. Remove the switch by unscrewing the mounting screws and disconnecting the wiring harness. Inspect the switch for damage; if it's faulty, replace it with a new or used part. Reassemble by reconnecting the harness, securing the switch in place, and reconnecting the battery to test functionality.
Where is the inhibitor switch on a 1990 Nissan 300zx?
it is located on the transmission itself
How do you remove 1996 Nissan 300ZX brake light switch?
To remove the brake light switch on a 1996 Nissan 300ZX, first disconnect the negative battery terminal to prevent any electrical issues. Locate the brake light switch, which is typically found near the top of the brake pedal assembly. Unscrew the switch from its mounting position and disconnect the wiring harness. Finally, remove the switch from the bracket, and you can replace it with a new one if needed.
What could make the headlight's and the wipers work some times and not work other times on a 1984 Nissan 300zx?
I had an 85 same problem with lights had to replace the switch on steering column about 150.00 for part from Nissan
Where is the ignition switch located on a 1986 Nissan 300ZX?
when you start the car up that's your ignition switch is located...
What does the red on off switch in the center cousel do in a 1987 Nissan 300ZX nonturbo?
On my '86, 300zx NA, the rocker switch on the console turns on the heated outside mirror (drivers side).
1984 Nissan 300zx have power to coil but no spark?
your coil is bad replace with new on
My air conditon blower don't run on your 85 Nissan 300zx?
ok....replace it
Where is the cylinder switch located in a 1990 Nissan 300zx?
In a 1990 Nissan 300ZX, the cylinder switch, also known as the ignition switch, is located on the steering column. To access it, you typically need to remove the plastic cover around the steering column. The switch is mounted near the ignition lock cylinder, which is where the key is inserted to start the vehicle.
Is there a Kill Switch on a 1992 Nissan 300ZX?
I'm 99.6% sure there isn't one designed into the system.
