if it is the sealed beem type then you have to remove the plastic shield from the front then you can just unbolt it if it is the composite type then you just unplug it from the back
Very easy to do. Pop the hood, look at back of headlight assembly. Push in and twist set cap at back of headlight to loosen. Unplug wire - there is a push down plastic nub on the connector that must be depressed as you remove the connector. Remove old halogen bulb. Install new halogen bulb. DON'T tough the glass or it makes the new bulbs burn out faster. Hold it by the plastic. Connect the wire and push until plastic nub clics in place. Re scew the set cap. You're done. Cost of bulb around $5.00 each.
They are small lights that you can replace by just counterclockwise screw it on the back of the light. You can just get to the left one but have to remove the air flow intake to get to the right one.
You have to take the front grill off to get at the headlight. Everything is easy after that.
To change a car headlight prop the hood open. Locate the headlight housings which will be towards the front of the vehicle. Find the bulbs and unscrew them. Insert the new bulbs.
replace the radiator, they are integrated.
Here is a link to replacement http://www.keystonekrawlers.com/Mods/Toyota/cvboot/CVBoot_replacement.htm
no
I believe all the stock speakers are 4". Not 100% sure though
sorry but no,the 22r version of the 4runner will work though
94 toyota camry
kind of a touchy motor, if in tip top shape and a 5spd manual. get up 23mpg with the 3.0v6.
The 1995 4Runner was the last model to be released from that series. The engine from 1990 until 1995 can all be swapped relatively easily.
wow, thanks for nothing. since there isn't a category for pre 95 Toyota pickups on this site, we have to assume that 93 pickup is what they meant. as far as the headlights, i believe you have to take the whole assembly out, the bulbs don't look like they can be replace seperately on my 94 at least. here's a link to a site that explains it better...http://www.toyotanation.com/forum/showthread.php?t=281540&highlight=headlight Toyota didnt make tacomas until 1995
Fuel injectors i'm told. Have same issue and this is what my mechanic told me. 3.0 3vze V6
The running board from a 95 or later Toyota 4Runner will work on a 94 model but will require minor modifications. The alignment of the brackets and the mounting holes vary in location.
To replace the horn on a 94 Toyota Corolla, you will need to remove the horn pad from the steering wheel. Once all screws have been loosened, you can lift the pad and replace the inner button, then just put the horn pad back on.