Here is a link to replacement
http://www.keystonekrawlers.com/Mods/Toyota/cvboot/CVBoot_replacement.htm
A CV boot is found on the axle of a vehicle. To replace the outer boot remove the axle bolt and pull the boot off. The inner boot requires removal of the whole axle.
Lift the vehicle using a jack. Inspect the CV boot for problems. Mark the axle. Separate the CV from the shaft. Remove the CV boot clamps. Use a mallet to knock the CV joint off the shaft. Remove the boot from the CV axle shaft.
you cannot just change the boot you will have to replace the whole axle
It is cheaper to replace the CV shaft than it is to replace the boot. If the boot has been torn for any length of time it will have collected dirt and water. That in itself spells disaster.
It is much cheaper to replace the CV shaft. Purchase a Haynes manual that is specific to your car.
500
They make replacements that are split in half, but they aren't generally recommended. What's best (unfortunately) is to remove the shaft and replace it with a stock cv boot. If the cv boot has been open to the elements for a while, damage in the cv joint might have occured.
Don't bother, just replace the entire axle. Once the boot is damaged, the CV joint is contaminated and it will not last very long. It's just an exercise in futility to replace the boot, and the effort is almost as great as if you replaced the entire half-shaft axle.
It would be in your best interest to replace the entire CV shaft. Replacing the boot is only a temporary fix, because the bearings inside the torn old boot have been exposed to the elements (dirt/water), and will destroy the bearings.
CV boot? Tierod boot? Ball joint boot? Driveshaft slip yoke boot? If its torn REPLACE it
If the CV boot is torn open forget about re-booting the joint, buy a remanufactured axle and replace it. If the boot is starting to crack or separate but has not torn open to the point you can see the cv joint itself you can re-boot it.Replacing CV JointsThere are places that sell the halfshaft axles already rebuilt as cheap as you can replace the joints. Call your local parts stores.
you can get the cv boot kit that you can glue the join on rather than taking the drive shaft off