answersLogoWhite

0


Best Answer

CV boot? Tierod boot? Ball joint boot? Driveshaft slip yoke boot? If its torn REPLACE it

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What are boots for 1991 Toyota truck Do thy have to be replaced?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the front brakes on a 1991 Toyota pickup truck?

changing front brake pads on 1991 Toyota truck


OILTYPE for 1991 Toyota truck?

10w30


How do you prime the oil pump on a 1991 Toyota V6 truck?

How do you prime the oil pump on a 1986 Toyota truck with 20r/22r engine


Is the catalytic converter bolted or welded on my 1991 Toyota 4 cylinder truck?

Its welded.


Wiring diagram for a 1991 Toyota pickup truck?

try this nathan-buchanan@tulsa.edu good luck


Will a 1999 Toyota motor fit into a 1991 Toyota truck?

Lol what KIND of Toyota motor - 3Y is one of the most common. as is the 2Y 4Y and 1RZ www.Toyota.com might be the place to go for more info.


Where is the fuel pump and how do you replace it on a 1991 Mitsubishi Might Max truck?

The fuel pump is located inside the fuel tank it can be replaced by dropping the tank the truck will have to be raised from the back


Where is diagnostic box on 1991 Toyota truck?

The box is on the passanger side engine bay next to the fuse box behind the battery.


What causes a squeaking sound of a 1991 Toyota 2wd truck when revving at high rpm?

bad or going bad alternator belt


How do you replace rear broken wheel stud on 1991 Toyota 4x4?

The hub will need to be removed and the stud pressed or drilled out to be replaced.


How do you replace the CV Boots in a 1991 Toyota 4WD truck?

The easy way to fix the boots is to cut off the old ones and use a split boot. But, these don't last very long. So the other way is to dissassemble the hub and unbolt the halfshaft from the side gear shaft. You then have to unbolt the lower control arm and dop it out of the way. Then you will have enough room to drop out the halfshaft. Then the rest is obvious.


What mileage do you need to change a cam belt on Toyota MR2 1991?

the cam/timing belt should be replaced at least every 60,000miles