I've just changed the heater illumination bulbs on the punto 07. take out the radio with 4 round 2" nails in the holes on front. undo the cage that holds the radio. pull off the panel under the heater nobs by downwards and there is 2 screws near the edge. take these out and the heater unit will come lose then the front is clipped in place at the top and bottom but be careful not to brake it. take this away and the bulbs are behind the transparent plastic held with 1 screw in middle
light out on the seat heater switch on passenger side. High low indicator is ok. How do you replace bulb?
The light in the switch can not be changed, the whole switch would need to be replaced.
If the heater still works the bulb is just burn out. I doubt you can change the light you will have to replace the switch.
i need to replace the temperature control light bulb on my 2004 silverado.
How to change bulb behind switch of fan Toyota Avenses
pull the heater control knob off and located behind is a small capless bulb pull out and then push in new bulb replace knob job done
Just changed mine it's simple just pop the bonnet and remove the retaining wires then take the appropriate bulb out and replace easy
BIUSx2123_
Pull off the central control with pliers and a rag to protect the switch. Extract the bulb using a short length of plastic tubing (it's too deep to get out with pliers). Stick the new one in, replace the knob and you're off.
You have to pull the switch out and the bulb is located behind that. Use something plastic to keep from scratching anything. Or a small screw driver.
By asking acablest to do it.
Low beam bulb burnt out? Replace bulb. Bulbs OK? If the dimmer switch is also the turn signal/cruise/headlight on and off switch, you probably have to replace the entire switch.