If you open the hood, there are 5 small nuts that hold that hood molding in place. simply remove those and you can remove/replace the hood molding.
If you open the hood, there are 5 small nuts that hold that hood molding in place. simply remove those and you can remove/replace the hood molding.
The 2002 Mazda Tribute OBD 2 port is on rear edge of dash; right of hood release
under the hood ,driver side.
passenger side under hood, where the hood meets the windshield you have to remove a few scews on the plastic trim
Just to the right of the hood release on backside of plastic covering
open hood, unplug, push them out, plug in new ones, put them in, close hood, party.
between the hood and the windshield
They are located under the hood on the passenger side fuse box, labeled "H/L LH" and "H/L RH".
The fuse box is under the hood release handle below the turn signal.
between the windshield and the hood the is a long black section of plastic molding. on the passenger side you will see a round black molding/screw that is about 2 inches in diameter and is also flush with the molding, unscrew it (phillips) and then slowly pull back molding, air filter element is underneath. reverse process to re-assemble Happy trails. DC
On the passenger side under the hood next to the fire wall (near the back of the glove box) under the cover plate and rain shield.
Open Hood. Open the hood of your Mazda 5. The hood release is located under the dashboard of your 5.